MN032 DAS Manager for FBS3/FBS4 cars

MN026 - Key Programming, EIS/ESL/DAS Manager/7-Gear ETC/ISM/Infra Red and password reader/Personalization/Activation/Coding

MN032

RequirementsAMSI18

MN032 is Mercedes FBS4 software license, designed by Abrites from the beginning to be the world leader in terms of Mercedes-Benz vehicles module replacement, both for new and used control units.

Here is what you can use MN032 for:

Set FBS4 Electronic Control Modules to virgin state

Read the personalization data from a FBS4 Control Modules and save it to a file

Program personalization data from a previously saved file to a FBS4 Control Module

FBS4 Control Modules Activation

Display FBS4 Control Modules status including those assembled in hybrid and electric vehicles without dismantling

VIN programming

 

Currently supported FBS4 - Control Modules:

by OBDII - Read FBS4 data, Program FBS4 data(Personalize), set to virgin state all MED17, EDC17, SID310, Delphi- CRD3 ECUs, (CR40, CR41, CR42, CR43, CR6, CR60, CR61, MED40, MED41* , MED177, MED1773, MED1775, CRR1, CRR1+, CRD3, CRD3S2). 48V starter generators too are fully supported by OBDII. The ones we are certain and have tested are the INV20EM01 type and their derivatives (hybrid vehicles)

* ZN051 Distribution Box is required for setting this module to virgin state.

OBDII support for  reading  FBS4 data from all MRD1, MRG1, MRG2, CRR2, EMS71 (no restrictions in production year!)

Bench and ZN051 Distribution box connection to the unit abilities include - set to virgin state MRD1, MRG1, CRR2 (confirmed for those produced before 2021). ZN051 Distribution box is required.

ZN051 Distribution box/ ZN030 ABPROG and Bench connection to the unit – support for all DSM/DSM222 and transmission control units VGS-DCT (dual clutch transmission) and VGSNAG3 (9G- Tronic).ZN051 Distribution box and ZN030 are required.

ECU MRD1, MRG1 (confirmed for those manufactured up to 2021) – Bench connection using ZN051.Distribution box is required.

Direct Shift Module (DSM) – Connection via ABPROG (ZN030) is required to connect to the module’s microcontroller to read and extract the needed data directly from it.

Required tools:

ZN051 Abrites Distribution Box

ZN030 Abrites ABPROG

CB030 Mercedes-Benz MD1/MG1 ECU connection cable for FBS4 Manager and ECU Programming Tool

CB403 Extended Cable Set for all TCUs which require bench connection

MN032

Data sheet

Brand
Mercedes
Smart

You might also like

16 other products in the same category: